Chapter 19
DLPs D200 to D299
If you want to complete an address summary, complete the following steps. If not, continue with
Step 6
Complete the address summary only if the ONS 15454 SDH is a gateway NE with multiple external
ONS 15454 SDH NEs attached with IP addresses in different subnets.
a.
b.
c.
Return to your originating procedure (NTP).
Step 7
DLP-D254 TCC2/TCC2P Card Active/Standby Switch Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Alarms tab.
Step 2
a.
b.
Click the Conditions tab. Verify that no unexplained conditions appear on the network. If unexplained
Step 3
conditions appear, resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting
Guide.
Step 4
On the network view map, double-click the node containing the TCC2/TCC2P cards that you are testing
to open the node in node view.
Step 5
Make a note of which TCC2/TCC2P card is active and which is standby by examining the LEDs on the
shelf graphic. TCC2/TCC2P cards are installed in Slot 7 and Slot 11. The active TCC2/TCC2P card has
a green ACT LED, and the standby TCC2/TCC2P card has an amber SBY LED.
On the shelf graphic, right-click the active TCC2/TCC2P card and choose Reset from the shortcut menu.
Step 6
In the Resetting Card dialog box, click Yes. After 20 to 40 seconds, a "lost node connection, changing
Step 7
to network view" message appears.
Click OK. On the network view map, the node where you reset the TCC2/TCC2P card will be gray.
Step 8
78-17194-01
In the RIP Address Summary area, click Create.
In the Create Address Summary dialog box, complete the following:
•
Summary Address—Enter the summary IP address.
•
Mask Length—Enter the subnet mask length using the up and down arrows.
Hops—Enter the number of hops. The smaller the number of hops, the higher the priority.
•
Click OK.
This task verifies that the TCC2/TCC2P cards can effectively switch from
one to another.
The test set specified by the acceptance test procedure, connected and
configured as specified in the acceptance test procedure.
DLP-D60 Log into CTC, page 17-49
Required
Onsite
Provisioning or higher
Verify that the alarm filter is not on. See the
page 19-25
as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
DLP- D254 TCC2/TCC2P Card Active/Standby Switch Test
"DLP-D227 Disable Alarm Filtering" task on
Cisco ONS 15454 SDH Procedure Guide, R7.0
Step
7.
19-59