Dlp- D84 Enable Node Security Mode - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
In the Circuit Destination area, complete the following:
Step 7
•
•
•
Click Finish.
Step 8
Return to your originating procedure (NTP).
Step 9
DLP-D84 Enable Node Security Mode
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The IP address assigned to the TCC2P LAN port must reside on a different subnet from the MIC-C/T/P
Caution
LAN port and the ONS 15454 SDH default router. Verify that the new TCC2P IP address meets this
requirement and is compatible with ONE 15454 SDH network IP addresses.
The node will reboot after you complete this task, causing a temporary disconnection between the CTC
Note
computer and the node.
Click the Provisioning > Security > Data Comm tabs.
Step 1
Click Change Mode.
Step 2
Review the information on the Change Secure Mode wizard page, then click Next.
Step 3
On the TCC Ethernet Port page, enter the IP address and subnet mask for the TCC2P LAN (TCP/IP) port.
Step 4
The IP address cannot reside on the same subnet as the MIC-C/T/P LAN port, nor the ONS 15454 SDH
default router.
Click Next.
Step 5
On the MIC-C/T/P Ethernet Port page, modify the MIC-C/T/P IP address, subnet mask, and default
Step 6
router, if needed. (You normally do not modify these fields if no ONS 15454 SDH network changes have
occurred.)
Click Next.
Step 7
Step 8 On the SOCKS Proxy Server Settings page, choose one of the following options:
78-17194-01
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
This task enables the ONS 15454 SDH security mode. When the security
mode is enabled, two IP addresses are assigned to the node. One address is
assigned to the MIC-C/T/P LAN port and the other to the TCC2P RJ-45
TCP/IP (LAN) port.
TCC2P cards must be installed.
NTP-D108 Back Up the Database, page 15-5
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser

DLP- D84 Enable Node Security Mode

Cisco ONS 15454 SDH Procedure Guide, R7.0
17-77