Dlp- D205 Clean Fiber Connectors With Cletop - Cisco ONS 15454 SDH Procedure Manual

DLP- D205 Clean Fiber Connectors with CLETOP

If you must replace a dust cap on a connector, first verify that the dust cap is clean.
Note
Return to your originating procedure (NTP).
Step 5
DLP-D205 Clean Fiber Connectors with CLETOP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the dust cap from the fiber connector.
Step 1
Press the lever down to open the shutter door. Each time you press the lever, you expose a clean wiping
Step 2
surface.
Insert the connector into the CLETOP cleaning cassette slot, rotate one quarter turn, and gently swipe
Step 3
downwards.
Use an inspection microscope to inspect each fiber connector for dirt, cracks, or scratches. If the
Step 4
connector is not clean, repeat Steps
Insert the fiber connector into the applicable adapter or attach a dust cap to the fiber connector.
Step 5
Note
Return to your originating procedure (NTP).
Step 6
DLP-D206 Clean the Fiber Adapters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-4
This task cleans the fiber connectors with CLETOP.
"Type A" Fiber Optic Connector Cleaner (CLETOP reel)
Optical receiver cleaning stick
None
Required
Onsite
None
If you must replace a dust cap on a connector, first verify that the dust cap is clean. To clean the
dust cap, wipe the outside of the cap using a dry, lint-free wipe and the inside of the dust cap
using a CLETOP stick swab (14100400).
This task cleans the fiber adapters.
CLETOP stick swab
None
Required
Onsite
None
1 to 3.
Chapter 19 DLPs D200 to D299
78-17194-01