Figure 19-10 Selecting Dual Roll Attributes - Cisco ONS 15454 SDH Procedure Manual

DLP- D236 Roll Two Cross-Connects on One Optical Circuit Using Automatic Routing
Figure 19-10
Click Next.
Step 6
In the Pivot/Fixed Point 1 window, click the square representing the fixed path of the first connection to
Step 7
be rolled
This path is a fixed point in the cross-connect involved in the roll process. The path identifier appears in
the text box below the graphic image. The path that is not selected contains the Roll From path. The Roll
From path is deleted after the roll is completed.
Click Next.
Step 8
Complete one of the following:
Step 9
If multiple Roll From paths exist, the Select Roll From dialog box appears. Select the path from
•
which you want to roll traffic and click OK.
If multiple Roll From paths do not exist, continue with
•
path changes states from DISCOVERED to ROLL_PENDING.
In the Pivot/Fixed Point 2 window, click the square that represents the fixed path of the second
Step 10
connection to be rolled.
The path that is not selected is the Roll From path. The Roll From path is deleted after the roll is
completed. The path identifier appears in the text box below the graphic image.
Click Next.
Step 11
In the Circuit Routing Preferences area, check Route Automatically to allow CTC to find the route
Step 12
(Figure
Using Required Nodes/Spans—If checked, you can specify nodes and spans to include or exclude
•
in the CTC-generated circuit route in
• Review Route Before Creation—If checked, you can review and edit the circuit route before the
circuit is created.
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-36
Selecting Dual Roll Attributes
(Figure 19-6 on page 19-31).
19-11). If you check Route Automatically, the following options are available:
Step 10. The circuit status for the Roll To
Step 15.
Chapter 19 DLPs D200 to D299
78-17194-01