Chapter 16 Power Down The Node - Cisco ONS 15454 SDH Procedure Manual

NTP- D114 Power Down the Node
In network view, verify that the node is not connected to a network.
Step 3
If the node is part of a working network, log out of the node and complete the
a.
an In-Service Node from a Linear ADM" procedure on page
MS-SPRing Node" procedure on page
on page
administrator. (Linear configurations will be deleted in
If the node is not connected to a working network and the current configurations are no longer
b.
required, continue with the next step.
Note
In node view, click the Circuits tab and verify that no circuits are displayed, then proceed to
Step 4
circuits appear, delete all the circuits that originate or terminate in the node, as follows:
Click the circuits that need to be deleted and click Delete.
a.
Click Yes.
b.
Repeat until no circuits appear.
In node view, click the Provisioning > Protection tabs and delete all protection groups:
Step 5
Click the protection group that needs to be deleted and click Delete.
a.
Click Yes.
b.
Repeat until no protection groups appear.
Step 6 In node view, click the Provisioning > Comm Channels tabs and delete all RS-DCC, MS-DCC, GCC,
or OSC terminations:
Click the regenerator section data communications channel (RS-DCC), multiplex section data
a.
communications channel (MS-DCC), generic communications channel (GCC), or optical service
channel (OSC) termination that needs to be deleted and click Delete.
Click Yes.
b.
Repeat until no RS-DCC, MS-DCC, GCC, or OSC terminations are present.
Note
For each installed STM-N or DS-N card, make sure all ports are in Locked-enabled,disabled service
Step 7
state:
In card view, click the Provisioning > Line tabs.
a.
Click under the Status column for each port and choose Locked,disabled.
b.
Remove all fiber connections to the cards.
Step 8
In node view, right-click an installed card and click Delete.
Step 9
Click Yes.
Step 10
After you have deleted the card, open the card ejectors and remove it from the node.
Step 11
Repeat Steps
Step 12
Cisco ONS 15454 SDH Procedure Guide, R7.0
16-2
14-12. If the node is part of a Software R6.0 MSTP configuration, consult your network
Current configurations will be saved if Steps
Before deleting the OSC termination, make sure the Ring ID is deleted. Click the Provisioning >
Comm Channels > OSC tabs. Select the Ring ID and click Delete.
7 through 11 for each installed card.
14-18, the
14-7, or the "NTP-D106 Remove an SNCP Node" procedure
Step 5.) Continue with the next step.
4 through 13
Chapter 16 Power Down the Node
"NTP-D322 Remove
"NTP-D213 Remove an
are skipped.
Step
78-17194-01
5. If