Table of Contents
Advertisement
NTP- D30 Create Users and Assign Security
NTP-D30 Create Users and Assign Security
Tools/Equipment
Step 1
If you are already logged in, continue with Step 2.
Note
Complete the
Step 2
Create a New User on Multiple Nodes" task on page 17-66
Note
Step 3
If you want to modify the security policy settings, complete the
Security" procedure on page
Stop. You have completed this procedure.
NTP-D316 Set Up Name, Date, Time, and Contact Information
Security Level
Step 1
already logged in, continue with Step 2.
Click the Provisioning > General tabs.
Step 2
Cisco ONS 15454 SDH Procedure Guide, R7.0
4-4
This procedure creates ONS 15454 SDH users and assigns their security
levels.
Superuser
You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 SDH can be used to set up other ONS 15454 SDH users. You can add up to 500 users
to one ONS 15454 SDH.
"DLP-D74 Create a New User on a Single Node" task on page 17-65
You must add the same user name and password to each node a user will access.
11-7.
This procedure provisions identification information for the node,
including the node name, a contact name and phone number, the location
of the node, and the date, time, and time zone.
NTP-D24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Superuser
Chapter 4
at the node where you want to create users.
or the
as needed.
"NTP-D205 Modify Users and Change
for the node you will turn up. If you are
Turn Up a Node
"DLP-D75
78-17194-01
Advertisement
Chapters
Table of Contents
