Dlp- D153 Set Up Snmp For An Ene - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
See the
Click Apply. The changes are applied. Confirm that the changes appear; if not, repeat the task.
Step 5
Note
Return to your originating procedure (NTP).
Step 6
DLP-D153 Set Up SNMP for an ENE
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP tabs.
Step 1
In the Trap Destinations area, click Create.
Step 2
In the Create SNMP Trap Destination dialog box, complete the following fields:
Step 3
•
•
•
•
Click OK. The node IP address of the node where you provisioned the new trap destination appears in
Step 4
the Trap Destinations area.
Click the node IP address in the Trap Destinations area. Verify the SNMP information that appears in
Step 5
the Selected Destination list.
If you want the SNMP agent to accept SNMP SET requests on certain MIBs, click the Allow SNMP Sets
Step 6
check box. If the box is not checked, SET requests are rejected.
Step 7 If you want to set up the SNMP proxy feature to allow network management, message reporting, and
performance statistic retrieval across ONS firewalls, click the Enable SNMP Proxy check box on the
SNMP tab.
78-17194-01
"DLP-D72 Create a 1:N Protection Group" task on page 17-63
To convert 1:1 protection groups, see the
Cards from 1:1 Protection to 1:N Protection" procedure on page
This procedure provisions the SNMP parameters for an ONS 15454 SDH
configured to be an ENE if you use SNMP proxy on the GNE.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite
Provisioning or higher
Destination IP Address—Enter the IP address of your NMS.
Community—Enter the SNMP community name. (For more information about SNMP, refer to the
"SNMP" chapter in the Cisco ONS 15454 SDH Reference Manual.)
The community name is a form of authentication and access control. The community name
Note
assigned to the ONS 15454 SDH is case-sensitive and must match the community name of
the NMS.
UDP Port—The default UDP port for SNMP traps is 162.
Trap Version—Choose either SNMPv1 or SNMPv2. Refer to your NMS documentation to determine
whether to use SNMPv1 or SNMPv2.

DLP- D153 Set Up SNMP for an ENE

for field descriptions.
"NTP-D91 Upgrade E1-N-14 and DS3 i-N-12 Protect
10-4.
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-45