Ntp- D325 Create An Stm Test Circuit Around The Ring - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
To set preferences for all members, choose the member protection type:
Step 12
•
•
•
Click Next. If you chose Fully Protected or PCA, click OK to continue. If not, continue with the next
Step 13
step.
In the Route Review and Edit area, node icons appear so you can route the circuit manually.
Step 14
Complete the
Step 15
Click Finish.
Step 16
Note
When all the circuits are created, the Circuits window appears. Verify that the circuit you created appears
Step 17
in the window.
Complete the
Step 18
Stop. You have completed this procedure.
NTP-D325 Create an STM Test Circuit around the Ring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
where you will create the circuit. If you are already logged in, continue with
Step 2 If you want to assign a name to the circuit source and destination ports before you create the circuit,
complete the
automatically based on circuit type, node name, and sequence number, continue with
From the View menu, choose Go to Network View.
Step 3
In the Circuit Creation dialog box, complete the following fields:
Step 4
•
78-17194-01
Fully Protected—Routes the circuit on a protected path.
•
Unprotected—Creates an unprotected circuit.
•
PCA—Routes the member on a MS-SPRing protection channel.
•
Fully Protected—Routes the circuit on a protected path.
Unprotected—Creates an unprotected circuit.
PCA—Routes the member on a MS-SPRing protection channel.
"DLP-D26 Provision a VCAT Circuit Route" task on page
Depending on the complexity of the network and number of members, the VCAT circuit creation
process might take several minutes.
"NTP-D62 Test High-Order Circuits" procedure on page
This procedure creates an STM test circuit that routes traffic around a ring
with the source and destination located on different ports of the same node.
None
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D314 Assign a Name to a Port" task on page
Circuit Type—Choose VC_HO_PATH_CIRCUIT.

NTP- D325 Create an STM Test Circuit around the Ring

17-20.
6-66.
at an ONS 15454 SDH on the network
Step
20-7. If you want CTC to assign a name
Cisco ONS 15454 SDH Procedure Guide, R7.0
2.
Step 3.
6-103