Chapter 10 Change Card Setting - Cisco ONS 15454 SDH Procedure Manual

Chapter 10 Change Card Settings
Onsite/Remote
Security Level
Changing card settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
Complete the
Step 1
STM-N card settings. If you are already logged in, proceed to Step 2.
Step 2 As needed, complete the
Perform any of the following tasks as needed:
Step 3
•
•
•
•
Note
Complete the
Step 4
Stop. You have completed this procedure.
NTP-D118 Modify Alarm Interface Controller–International
Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
AIC-I card settings. If you are already logged in, proceed to Step 2.
As needed, complete the
Step 2
Perform any of the following tasks as needed:
Step 3
78-17194-01
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"NTP-D108 Back Up the Database" procedure on page
DLP-D108 Change Line Settings for STM-N Cards, page 18-9
DLP-D343 Change SDH Threshold Settings for STM-N Cards, page 20-54
DLP-D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards, page 18-12
DLP-D216 Change the STM-N Card ALS Maintenance Settings, page 19-14
To change settings on the Provisioning > VC4 tab, go to the
Path Performance Monitoring" task on page
see Chapter 9, "Manage Alarms."
"NTP-D108 Back Up the Database" procedure on page
This procedure changes the AIC-I card external alarms and controls
(environmental alarms) and changes orderwire settings.
None
NTP-D247 Provision External Alarms and Controls on the Alarm Interface
Controller–International, page 9-8
page
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"NTP-D108 Back Up the Database" procedure on page
NTP- D118 Modify Alarm Interface Controller–International Settings
18-21. To change settings on the Alarm Profiles tab,
17-76.
Cisco ONS 15454 SDH Procedure Guide, R7.0
at the node where you want to change the
15-5.
"DLP-D122 Enable Intermediate
15-5.
and the DLP-D83 Provision Orderwire,
at the node where you want to change the
15-5.
10-3