Cisco ONS 15454 SDH Procedure Manual page 210

NTP- D55 Create a Manually Routed Low-Order VC3 Circuit
State—Choose the administrative state to apply to all of the cross-connects in a circuit:
•
–
–
–
–
For additional information about circuit service states, refer to the "Circuits and Tunnels" chapter
in the Cisco ONS 15454 SDH Reference Manual.
Apply to drop ports—Select this check box if you want to apply the state chosen in the State field
•
to the circuit source and destination ports. CTC applies the circuit state to the ports only if the circuit
bandwidth is the same as the port bandwidth or, if the port bandwidth is larger than the circuit, the
circuit must be the first circuit to use the drop port. If not, a Warning dialog box shows the ports
where the circuit state could not be applied. If the box is unchecked, CTC does not change the state
of the source and destination ports.
Note
Protected Drops—Select this check box if you want the circuit routed on protected drops only, that
•
is, to ONS 15454 SDH cards that are in 1:1, 1:N, or 1+1 protection. If you select this check box,
CTC displays only protected cards and ports as source and destination choices.
If the circuit will be routed on an SNCP ring, complete the
Step 9
During Circuit Creation" task on page
Click Next.
Step 10
Complete the
Step 11
page 20-9.
In the Circuit Routing Preferences area
Step 12
Set the circuit path protection:
Step 13
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
alternate paths), and the path diversity options apply only to SNCP path segments, if any exist.
• To create an unprotected circuit, uncheck Fully Protected Path and continue with
To route the circuit on an MS-SPRing protection channel, if available, uncheck Fully Protected
•
Path, check Protection Channel Access, click Yes in the Warning dialog box, then continue with
Step
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-36
Unlocked—Puts the circuit cross-connects in the Unlocked-enabled service state.
Locked,disabled—Puts the circuit cross-connects in the Locked-enabled,disabled service state.
Traffic is not passed on the circuit.
Unlocked,automaticInService—Puts the circuit cross-connects in the
Unlocked-disabled,automaticInService service state and suppresses alarms and conditions.
When the connections receive a valid signal, the service state automatically changes to
Unlocked-enabled.
Locked,maintenance—Puts the circuit cross-connects in the Locked-enabled,maintenance
service state. The maintenance state does not interrupt traffic flow; it suppresses alarms and
conditions and allows loopbacks to be performed on the circuit. Use Locked,maintenance for
circuit testing or to suppress circuit alarms temporarily. Change the administrative state to
Unlocked; Unlocked,automaticInService; or Locked,disabled when testing is complete. See the
"DLP-D230 Change a Circuit State" task on page
If ports managed into the Unlocked administrative state are not receiving signals, loss of
signal alarms are generated and the port service state transitions to
Unlocked-disabled,failed.
"DLP-D318 Provision a Low-Order VC3 Circuit Source and Destination" task on
14. Fully protected paths might or might not have SNCP path segments (with primary and
17.
Chapter 6
19-26.
"DLP-D218 Provision SNCP Ring Selectors
19-17. Otherwise, continue with
(Figure 6-2 on page 6-10), uncheck Route Automatically.
Create Circuits and Low-Order Tunnels
Step 10.
Step 17.
78-17194-01