Using Static Ip Addresses - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the
Same Subnet Using Static IP Addresses
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the operating system that is installed on your computer:
Step 1
a.
b.
c.
According to the Windows operating system installed on your computer, perform one of the following
Step 2
steps:
•
•
•
•
If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
Step 3
configuration:
a.
b.
c.
d.
e.
f.
g.
78-17194-01
DLP- D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the Same Subnet Using Static IP
This task sets up your computer for a local craft connection to the
ONS 15454 SDH when:
•
•
None
NTP-D278 Set Up Computer for CTC, page 3-2
As needed
Onsite or remote
None
From the Windows Start menu, choose Settings > Control Panel.
In Windows XP, you can choose Control Panel directly from the Start menu. Make sure you
Note
are in Classic View before continuing with this procedure.
In the Control Panel window, double-click the System icon.
On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP.
For Windows 98, complete
For Windows NT 4.0, complete
For Windows 2000, complete
For Windows XP, complete
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel dialog box, click the Network icon.
In the Network dialog box, choose TCP/IP for your network interface card (NIC), then click
Properties.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
Click the WINS Configuration tab and choose Disable WINS Resolution.
Click the IP Address tab.
In the IP Address window, click Specify an IP address.
You will connect to one ONS 15454 SDH; if you will connect to
multiple ONS 15454 SDH nodes, you might need to reconfigure your
computer's IP settings each time you connect to an ONS 15454 SDH.
You need to use non-ONS 15454 SDH applications such as ping and
tracert (trace route).
Step 3.
Step 4.
Step 5.
Step 6.
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-37