Figure 1-27 Ons 15454 Etsi Fmec Cover - Cisco ONS 15454 Series Procedure Manual

Required Tools and Equipment (ETSI)
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring
spring snaps into place.
Figure 1-27
Pin hinge
FMEC cover
Hinge-locking
Attach the ground wire to the shelf.
Step 4
Step 5 Attach the washer and nut.
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
Step 7 Continue with the
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-64
ONS 15454 ETSI FMEC Cover
spring
"NTP-G14 Install DWDM Equipment" procedure on page
Chapter 1
(Figure 1-27). Push the cover onto the right pin until the
F A N
F A IL
C R
IT
M A
J
M IN
Install the Cisco ONS 15454 Shelf Assembly
1-66.
78-19286-01