Cisco ONS 15454 SDH Procedure Manual page 751

Chapter 20 DLPs D300 to D399
Cisco recommends a maximum of 84 DCC tunnel connections. Terminated RS-DCCs used by the
Note
ONS 15454 SDH cannot be used as DCC tunnel endpoints, and an RS-DCC that is used as a DCC tunnel
endpoint cannot be terminated. All DCC tunnel connections are bidirectional.
Step 1 In network view, click the Provisioning > Overhead Circuits tabs.
Click Create.
Step 2
In the Overhead Circuit Creation dialog box, complete the following in the Circuit Attributes area:
Step 3
Name—Type the tunnel name.
•
Circuit Type—Choose one:
•
–
–
Click Next.
Step 4
In the Circuit Source area, complete the following:
Step 5
Node—Choose the source node.
•
Slot—Choose the source slot.
•
Port—If displayed, choose the source port.
•
Channel—These options appear if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of
•
the following:
–
–
–
–
DCC options do not appear if they are used by the ONS 15454 SDH (DCC1) or other tunnels.
Step 6 Click Next.
Step 7 In the Circuit Destination area, complete the following:
Node—Choose the destination node.
•
Slot—Choose the destination slot.
•
Port—If displayed, choose the destination port.
•
Channel—These options appear if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of
•
the following:
–
–
–
–
DCC options do not appear if they are used by the ONS 15454 SDH (DCC1) or other tunnels.
Click Finish.
Step 8
78-17194-01
DCC Tunnel-D1-D3—Allows you to choose either the RS-DCC (D1-D3) or an MS-DCC
(D4-D6, D7-D9, or D10-D12) as the source or destination endpoints.
DCC Tunnel-D4-D12—Provisions the full MS-DCC as a tunnel.
DCC1 (D1-D3)—This is the RS-DCC.
DCC2 (D4-D6)—This is MS-DCC 1.
DCC3 (D7-D9)—This is MS-DCC 2.
DCC4 (D10-D12)—This is MS-DCC 3.
DCC1 (D1-D3)—This is the RS-DCC.
DCC2 (D4-D6)—This is MS-DCC 1.
DCC3 (D7-D9)—This is MS-DCC 2.
DCC4 (D10-D12)—This is MS-DCC 3.
DLP- D361 Create a DCC Tunnel
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-67