Dlp- D227 Disable Alarm Filtering - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
DLP-D227 Disable Alarm Filtering
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At node, network, or card view, click the Alarms tab.
Step 1
Click the Filter tool at the lower-right side of the bottom toolbar.
Step 2
Alarm filtering is enabled if the tool is indented and disabled if the tool is raised (not selected).
If you want alarm filtering disabled when you view conditions, click the Conditions tab and click the
Step 3
Filter tool.
If you want alarm filtering disabled when you view alarm history, click the History tab and click the
Step 4
Filter tool.
Return to your originating procedure (NTP).
Step 5
DLP-D229 View Circuits on a Span
Purpose
Tools/Equipment
Prerequisite Procedures Circuits must be created on the span. See
Required/As Needed
Onsite/Remote
Security Level
From the View menu at node view, choose Go to Network View. If you are already in network view,
Step 1
continue with
Right-click the green line containing the circuits that you want to view and choose one of the following:
Step 2
•
•
78-17194-01
This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
None
DLP-D225 Enable Alarm Filtering, page 19-24
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
This task allows you to view circuits on an ONS 15454 SDH span.
None
Low-Order Tunnels."
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Step 2.
Circuits—To view MS-SPRing, SNCP ring, 1+1, virtual concatenated (VCAT), or unprotected
circuits on the span.
PCA Circuits—To view circuits routed on an MS-SPRing protected channel. (This option does not
appear if the span you right-clicked is not an MS-SPRing span.)

DLP- D227 Disable Alarm Filtering

Chapter 6, "Create Circuits and
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-25