Dlp- D127 View Far-End Pm Counts - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
DLP-D127 View Far-End PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab.
Click the Far End radio button.
Step 3
Click Refresh. All PM parameters recorded by the far-end node for the selected card on the outgoing
Step 4
signal appear. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Step 5 View the Curr column to find PM counts for the current time interval.
Step 6 View the Prev-n columns to find PM counts for the previous time intervals.
Return to your originating procedure (NTP).
Step 7
DLP-D129 Reset Current PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Click Baseline.
Step 3
The Baseline button clears the PM counts displayed in the current time interval, but does not clear the
PM counts on the card. When the current time interval expires or the window view changes, the total
number of PM counts on the card and on the window appear in the appropriate column. The baseline
values are discarded if you change views to a different window and then return to the Performance
Monitoring window.
78-17194-01
This task enables you to view far-end PM counts for the selected card
and port. Only cards that allow far-end monitoring have the Far End
radio button as an option.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
This task clears the current PM count, but it does not clear the
cumulative PM count. This task allows you to see how quickly PM
counts rise.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D127 View Far-End PM Counts

18-25