Ntp- D168 Enable, Modify, Or Disable Alarm Severity Filtering - Cisco ONS 15454 SDH Procedure Manual

Chapter 9 Manage Alarms
NTP-D168 Enable, Modify, or Disable Alarm Severity Filtering
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
severity filtering. If you are already logged in, continue with
As necessary, complete the
Step 2
alarm filtering at the card, node, and network views for all nodes in the network. Alarm filtering can be
enabled for alarms, conditions, or events.
Step 3 As necessary, complete the
task on page 21-12
conditions.
As necessary, complete the
Step 4
profile filtering for all network nodes.
Stop. You have completed this procedure.
NTP-D72 Suppress Alarms or Discontinue Alarm Suppression
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step
Complete the
Step 2
autonomous messages that clear specific raised alarms and cause suppressed alarms to appear in the
Conditions window.
78-17194-01
This procedure starts, changes, or stops alarm filtering for one or more
severities in the Alarms, Conditions, and History windows in all network
nodes.
None
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D225 Enable Alarm Filtering" task on page
"DLP-D428 Modify Alarm, Condition, and History Filtering Parameters"
to modify the alarm filtering for network nodes to show or hide particular alarms or
"DLP-D227 Disable Alarm Filtering" task on page 19-25
This procedure prevents alarms from being reported for a port, card, or
node in circumstances when an alarm or condition is known to exist but
you do not want to include it in the Alarms or History display.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page
2.
"DLP-D430 Suppress Alarm Reporting" task on page 21-15

NTP- D168 Enable, Modify, or Disable Alarm Severity Filtering

at the node where you want to enable alarm
Step 2.
17-49. If you are already logged in, continue with
to enable the node to send
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-24. This task enables
to disable alarm
9-7