Ntp- D145 Create An E-Series Multicard Etherswitch Manual Cross-Connect - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
Complete the
Step 23
page
Step 24 Complete the
Stop. You have completed this procedure.
NTP-D145 Create an E-Series Multicard EtherSwitch Manual
Cross-Connect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In this procedure, cross-connect refers to a circuit connection created within the same node between the
Note
Ethernet card and an STM-N card connected to third-party equipment. You create cross-connects at the
source and destination nodes so an Ethernet circuit can be routed from source to destination across
third-party equipment.
Complete the
Step 1
logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
automatically based on circuit type, node name, and sequence number, continue with
Step 3 Complete the
VLAN capacity is available. (You will create a VLAN during each circuit creation task.)
Step 4 Verify that the Ethernet card that will carry the circuit is provisioned for Multicard EtherSwitch Group.
See the
Provision and enable the Ethernet ports. See
Step 5
page
From the View menu, choose Go to Network View.
Step 6
Click the Circuits tab and click Create.
Step 7
Step 8 In the Circuit Creation dialog box, complete the following fields:
•
•
•
Click Next.
Step 9
78-17194-01
"DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership" task on
19-19.
"NTP-D146 Test E-Series Circuits" procedure on page
This procedure manually creates multicard EtherSwitch cross-connects
between E-Series Ethernet cards and STM-N cards connected to non-ONS
equipment.
E-Series Ethernet cards must be installed at the circuit source node.
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Step 2.
"DLP-D314 Assign a Name to a Port" task on page
"DLP-D99 Determine Available VLANs" task on page 17-98
"DLP-D246 Provision E-Series Ethernet Card Mode" task on page
19-18.
Circuit Type—Choose VC_HO_PATH_CIRCUIT.
Number of Circuits—Leave the default unchanged (1).
Auto-ranged—Unavailable.

NTP- D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect

at a circuit endpoint. If you are already
20-7. If you want CTC to assign a name
"DLP-D220 Provision E-Series Ethernet Ports" task on
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-89.
Step 3.
to verify that sufficient
19-50.
6-85