Table of Contents
Advertisement
Chapter 10
Change Card Settings
NTP-D311 Modify Port Settings and PM Parameter Thresholds
for SAN Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
STM-N card settings. If you are already logged in, proceed to Step 2.
As needed, complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
•
Step 4
As needed, complete the
Stop. You have completed this procedure.
NTP-D330 Change Card or PPM Service State
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
On the STM64-XFP and MRC-12 cards, the PPM is equivalent to an optical port.
Step 1
Complete the
card service state.
Step 2
Click the Inventory tab.
78-17194-01
This procedure changes the line settings and PM parameter thresholds for
FC_MR-4 cards.
None
NTP-D286 Install the FC_MR-4 Cards, page 2-12
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
"NTP-D108 Back Up the Database" procedure on page
DLP-D354 Change General Port Settings for the FC_MR-4 Card, page 20-59
DLP-D355 Change Distance Extension Port Settings for the FC_MR-4 Card, page 20-61
DLP-D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card, page 20-63
DLP-D465 Create FC_MR-4 RMON Alarm Thresholds, page 21-40
DLP-D466 Delete FC_MR-4 RMON Alarm Thresholds, page 21-44
"NTP-D108 Back Up the Database" procedure on page
This procedure changes a card or port's service state, which is an
autonomously generated state that gives the overall condition of the port.
None
Chapter 2, "Install Cards and Fiber-Optic Cable"
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
NTP- D311 Modify Port Settings and PM Parameter Thresholds for SAN Cards
at the node where you want to change the
at the node where you want to change the
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-5.
15-5.
10-5
Advertisement
Chapters
Table of Contents
