Cisco ONS 15454 SDH Procedure Manual page 136

NTP- D339 Point-to-Point Network Acceptance Test
Connect the test set receive (Rx) connector to the circuit transmit (Tx) connector on the circuit
b.
source card.
Step 11 Verify that the test set shows a clean signal. If a clean signal is not present, repeat Steps
make sure the test set and cabling are configured correctly.
Step 12 If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
again, refer to the next level of support.
Inject BIT errors from the test set. Verify that the errors appear at the test set, indicating a complete
Step 13
end-to-end circuit.
Complete the
Step 14
Complete the
Step 15
Complete the
Step 16
Step 17 Set up and complete a bit error rate (BER) test. Use the existing configuration and follow your site
requirements for the specified length of time. Record the test results and configuration.
Remove any loopbacks, switches, or test sets from the nodes after all testing is complete.
Step 18
Step 19 From the View menu, choose Go to Network View.
Step 20 Click the Alarms tab.
a. Verify that the alarm filter is not on. See the
page 19-25
b. Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
Complete the
c.
Step 21 Repeat Steps
Step 22 If a node fails any test, repeat the test while verifying correct setup and configuration. If the test fails
again, refer to the next level of support.
Delete the test circuit. See the
Step 23
After all tests are successfully completed and no alarms exist in the network, the network is ready for
service application.
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-6
"DLP-D254 TCC2/TCC2P Card Active/Standby Switch Test" task on page
"DLP-D255 Cross-Connect Card Side Switch Test" task on page
"DLP-D88 Optical 1+1 Protection Test" task on page
as necessary.
"DLP-D147 Export CTC Data" task on page 18-38
9 through 20 for the other point-to-point node.
"DLP-D27 Delete Circuits" task on page
17-81.
"DLP-D227 Disable Alarm Filtering" task on
to export the alarm information.
17-21.
Chapter 5 Turn Up a Network
6 through 10 to
19-59.
19-60.
78-17194-01