Cisco ONS 15454 SDH Procedure Manual page 283

Manage Circuits
This chapter explains how to manage Cisco ONS 15454 SDH electrical, STM-N, Ethernet, and virtual
concatenated (VCAT) circuits.
Before You Begin
To create circuits, see
To clear any alarm or trouble conditions, refer to the Cisco ONS 15454 SDH Troubleshooting Guide.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
78-17194-01
Chapter 6, "Create Circuits and Low-Order Tunnels."
NTP-D199 Locate and View Circuits, page
NTP-D200 View Cross-Connect Card Resource Usage, page
NTP-D287 Modify and Delete Circuits, page
change the active and standby colors of spans; change signal fail (SF), signal degrade (SD),
reversion time, and payload defect indication-path (PDI-P) settings for subnetwork connection
protection (SNCP) ring circuits; delete a circuit; or add or delete a VCAT member.
NTP-D288 Modify and Delete Overhead Circuits and Server Trails, page
to change a tunnel type, repair an IP circuit, or delete an overhead circuit.
NTP-D78 Create a Monitor Circuit, page
bidirectional circuits.
NTP-D329 Create a J0 Section Trace, page
changes to circuit traffic.
NTP-D79 Create a J1 or J2 Path Trace, page
changes to circuit traffic.
NTP-D332 Bridge and Roll Traffic, page
NTP-D309 Reconfigure Circuits, page
NTP-D310 Merge Circuits, page
NTP-D352 Manage VLANs, page
C H A P T E R
7-2—Complete as needed.
7-4—Complete as needed to edit a circuit name;
7-5—Complete as needed to monitor traffic on primary
7-6—Complete as needed to monitor interruptions or
7-8—Complete as needed to monitor interruptions or
7-9—Complete as needed to reconfigure circuits.
7-10—Complete as needed to reconfigure circuits.
7-11—Complete as needed to merge circuits.
7-11—Complete as needed to view, create, or delete VLANs.
Cisco ONS 15454 SDH Procedure Guide, R7.0
7
7-2—Complete as needed.
7-4—Complete as needed
7-1