Dlp- D237 Roll Two Cross-Connects On One Optical Circuit Using Manual Routing - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
DLP-D237 Roll Two Cross-Connects on One Optical Circuit Using Manual
Routing
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go To Network View.
Step 1
Click the Circuits tab.
Step 2
Click the circuit that you want to roll to a new path. The circuit must have a DISCOVERED status for
Step 3
you to start a roll.
From the Tools menu, choose Circuits > Roll Circuit.
Step 4
In the Roll Attributes area, complete the following
Step 5
a.
b.
Click Next.
Step 6
In the Pivot/Fixed Point 1 window, click the square representing the fixed path of the first cross-connect
Step 7
to be rolled
This path is a fixed point in the cross-connect involved in the roll process. The path identifier appears in
the text box below the graphic image. The path that is not selected contains the Roll From path. The
Roll From path is deleted after the roll is completed.
Click Next.
Step 8
Complete one of the following:
Step 9
•
•
In the Pivot/Fixed Point 2 window, click the square that represents the fixed path of the second
Step 10
connection to be rolled.
The path that is not selected is the Roll From path. The Roll From path is deleted after the roll is
complete. The path identifier appears in the text box below the graphic image.
Step 11 Click Next.
Step 12 In the Circuit Routing Preferences area, uncheck Route Automatically.
78-17194-01
This task reroutes a network path of an optical circuit using manual
routing.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning and higher
From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll or Manual to
create a manual roll.
From the Circuit Type drop-down list, choose Dual to indicate that you want to roll two connections
on the chosen circuit.
(Figure 19-6 on page
If multiple Roll From paths exist, the Select Roll From dialog box appears. Select the path from
which you want to roll traffic and click OK, then click Next.
If multiple Roll From paths do not exist, click Next and continue with
the Roll From path changes from DISCOVERED to ROLL_PENDING.

DLP- D237 Roll Two Cross-Connects on One Optical Circuit Using Manual Routing

(Figure 19-10 on page
19-31).
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-36):
Step 10. The circuit status for
19-39