Cisco ONS 15454 SDH Procedure Manual page 180

NTP- D127 Verify Network Turn-Up
Click the Network tab. Verify that the IP address, Subnet mask, Default Router, Prevent LCD IP
c.
Config, and Gateway Settings are correctly provisioned. If not, make corrections using the
"NTP-D201 Change CTC Network Access" procedure on page
Click the Protection tab. Verify that protection groups are created as specified in your site plan. If
d.
the protection groups are not created, complete the
Settings" procedure on page
If the node is in an MS-SPRing, click the MS-SPRing tab. (If the node is not in an MS-SPRing,
e.
continue with Step f.) Verify that the following items are provisioned as specified in your site plan:
•
•
•
•
•
If you need to make corrections, see the
page 5-10
Click the Security tab. Verify that the users and access levels are provisioned as specified. If not,
f.
see the
information.
If Simple Network Management Protocol (SNMP) is used, click the SNMP tab and verify the trap
g.
and destination information. If the information is not correct, see the
Settings" procedure on page 11-7
Click the Comm Channels tab. Verify that DCCs were created to the applicable STM-N slots and
h.
ports. If DCCs were not created for the appropriate STM-N slots and ports, see
a Network"
Click the Timing tab. Verify that timing is provisioned as specified. If not, use the
i.
Change Node Timing" procedure on page 11-6
Click the Alarm Profiles tab. If you provisioned optional alarm profiles, verify that the alarms are
j.
provisioned as specified. If not, see the
Profiles" procedure on page 9-6
Verify that the network element (NE) defaults listed in the status area of the node view window are
k.
correct.
Repeat
Step 7
Complete the appropriate circuit creation procedure from the NTP list in the
Step 8
on page
Stop. You have completed this procedure.
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-6
11-5.
MS-SPRing type (2-fiber or 4-fiber)
MS-SPRing ring ID and node IDs
Ring reversion time
East and west card assignments
(4-fiber MS-SPRings only) Span reversion and east/west protect card assignments
for instructions.
"NTP-D30 Create Users and Assign Security" procedure on page 4-4
and complete the turn-up procedure appropriate for your network topology.
Step 6 for each node in the network.
6-1.
Chapter 6
"NTP-D203 Modify or Delete Card Protection
"NTP-D40 Provision MS-SPRing Nodes" procedure on
to correct the information.
to make the changes.
"NTP-D71 Create, Download, and Assign Alarm Severity
to change the information.
Create Circuits and Low-Order Tunnels
11-2.
to correct the
"NTP-D87 Change SNMP
Chapter 5, "Turn Up
"NTP-D85
"Before You Begin" section
78-17194-01