Dlp- D194 Clear An Ms-Spring Force Ring Switch - Cisco ONS 15454 SDH Procedure Manual

DLP- D194 Clear an MS-SPRing Force Ring Switch

DLP-D194 Clear an MS-SPRing Force Ring Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > MS-SPRing tabs.
Step 2
Click Edit.
Step 3
To clear a Force switch on the west line:
Step 4
a.
b.
c.
To clear a Force switch on the east line:
Step 5
a.
b.
c.
On the MS-SPRing network graphic, a green and a purple span line connects each node. This is the
normal display for MS-SPRings when protection operations are not invoked.
From the File menu, choose Close.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-D195 Verify Timing in a Reduced Ring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Timing > General tabs.
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-82
This task removes a Force switch from an MS-SPRing port.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite
Provisioning or higher
Right-click the MS-SPRing west port where you want to clear the protection switch and choose
Set West Protection Operation. Ports with a force switch applied are marked with an F.
In the Set West Protection Operation dialog box, choose CLEAR from the drop-down list. Click
OK.
In the Confirm MS-SPRing Operation dialog box, click Yes.
Right-click the MS-SPRing east port where you want to clear the protection switch and choose
Set East Protection Operation. Ports with a Force switch applied are marked with an F.
In the Set East Protection Operation dialog box, choose CLEAR from the drop-down list. Click OK.
In the Confirm MS-SPRing Operation dialog box, click Yes.
This task verifies timing in the ring where you removed a node.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite/remote
Provisioning or higher
Chapter 18 DLPs D100 to D199
78-17194-01