Cisco ONS 15454 SDH Procedure Manual page 523

Chapter 18 DLPs D100 to D199
Table 18-1 STM-N Card Line Settings (continued)
Parameter Description
Admin State Sets the port administrative service state unless
network conditions prevent the change. For
more information about administrative states,
refer to the "Administrative and Service States"
appendix of the Cisco ONS 15454 SDH
Reference Manual.
Service State (Display only) Identifies the autonomously
generated state that gives the overall condition
of the port. Service states appear in the format:
Primary State-Primary State Qualifier,
Secondary State. For more information about
service states, refer to the "Administrative and
Service States" appendix of the
Cisco ONS 15454 SDH Reference Manual.
AINS Soak Sets the automatic in-service soak period.
Type Displays the port as SDH.
ALS Mode Sets the automatic laser shutdown function.
78-17194-01
DLP- D108 Change Line Settings for STM-N Cards
Options
Unlocked—Puts the port in service. The port service
•
state changes to Unlocked-enabled.
Unlocked,automaticInService—Puts the port in
•
automatic in-service. The port service state changes
to Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port from service
and disables it. The port service state changes to
Locked-enabled,disabled.
Locked,maintenance—Removes the port from
•
service for maintenance. The port service state
changes to Locked-enabled,maintenance.
Unlocked-enabled—The port is fully operational
•
and performing as provisioned.
Unlocked-disabled,automaticInService—The port is
•
out-of-service, but traffic is carried. Alarm reporting
is suppressed. The ONS node monitors the ports for
an error-free signal. After an error-free signal is
detected, the port stays in the
Unlocked-disabled,automaticInService state for the
duration of the soak period. After the soak period
ends, the port service state changes to
Unlocked-enabled.
• Locked-enabled,disabled—The port is
out-of-service and unable to carry traffic.
• Locked-enabled,maintenance—The port is
out-of-service for maintenance. Alarm reporting is
suppressed, but traffic is carried and loopbacks are
allowed.
Duration of valid input signal, in hh.mm format,
•
after which the card becomes in service (IS)
automatically
0 to 48 hours, 15-minute increments
•
SDH
•
Disabled
•
• Auto Restart
• Manual Restart
• Manual Restart for Test
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-11