Dlp- D191 Delete A Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note
Return to your originating procedure (NTP).
Step 5
DLP-D191 Delete a Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic, right-click the card that you want to remove and choose Delete Card.
Step 1
Ensure that none of the following conditions apply:
Step 2
•
•
•
•
•
•
Return to your originating procedure (NTP).
Step 3
78-17194-01
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task deletes a card from CTC.
None
DLP-D60 Log into CTC, page 17-49
As needed
Both
Provisioning or higher
The card is a TCC2/TCC2P card. To replace a TCC2/TCC2P card, refer to the
Cisco ONS 15454 SDH Troubleshooting Guide.
The card is part of a protection group; see the
page 18-47.
The card has circuits; see the
The card is part of an MS-SPRing; see the
page 14-7.
The card is being used for timing; see the
page 18-48.
The card has a DCC termination; see the
Termination" task on page 20-66
task on page 20-68.
If you delete a card in CTC but do not remove the card from shelf, it will reboot and reappear
Note
in CTC.
"NTP-D257 Change the PM Display" procedure
"DLP-D155 Delete a Protection Group" task on
"DLP-D27 Delete Circuits" task on page
"NTP-D213 Remove an MS-SPRing Node" procedure on
"DLP-D157 Change the Node Timing Source" task on
"DLP-D360 Delete a Regenerator-Section DCC
or "DLP-D362 Delete a Multiplex-Section DCC Termination"
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D191 Delete a Card

17-21.
18-79