Cisco ONS 15454 SDH Procedure Manual page 793

Chapter 21 DLPs D400 to D499
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 1
Click the Provisioning > Port tabs.
Step 2
Modify any of the settings described in
Step 3
Table 21-1
Parameter
#
Port Name
State
Port Rate
Link Rate
Max GBIC
Rate
Enable Link
Recovery
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
78-17194-01
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Table
FC_MR-4 Card Port Settings
Description
(Display only) Displays the port number. 1 through 4
Provides the ability to assign the
specified port a name.
Places port in service, out of service, or
out of service-maintenance.
Selects the Fibre Channel interface.
Displays the actual rate of the port.
Displays the maximum Gigabit Interface
Converter (GBIC) rate. Cisco supports
two GBICs for the FC_MR-4 card
(ONS-GX-2FC-SML and
ONS-GX-2FC-MMI). If used with
another GBIC, "Contact GBIC vendor"
appears in this field.
Enables or disables link recovery if a
local port is inoperable. If enabled, a link
reset occurs when there is a loss of
transport from a cross-connect switch, a
protection switch, or an upgrade.
DLP- D438 Change Port Settings for the FC_MR-4 Card
21-1.
Options
User-defined. Name can be up to
32 alphanumeric/special characters.
Blank by default.
See the "DLP-D314 Assign a Name to a
Port" task on page
IS
•
OOS
•
OOS_MT
•
• 1 Gbps
• 2 Gbps
—
—
—
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-7.
21-27