Table of Contents
Advertisement
DLP- D99 Determine Available VLANs
DLP-D99 Determine Available VLANs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
In any CTC view, click the Circuits tab.
Step 2
Click any existing Ethernet circuit to highlight that row.
Step 3
Click Edit, then click the VLANs tab.
The Edit Circuit dialog box shows the number of VLANs used by circuits and the total number of
VLANs available for use.
Step 4
Determine that number of available VLANs listed is sufficient for the number of E-Series Ethernet
circuits that you will create.
Multiple E-Series Ethernet circuits with spanning tree enabled block each other if the circuits traverse
Caution
the same E-Series Ethernet card and use the same VLAN.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 SDH Procedure Guide, R7.0
17-98
This task verifies that the network has the capacity to support the additional
new VLANs required for the creation of E-Series circuits. It does not apply
to E-Series cards in port-mapped mode.
E-Series Ethernet cards must be installed at each end of the Ethernet
circuit.
NTP-D127 Verify Network Turn-Up, page 6-5
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Chapter 17
DLPs D1 to D99
78-17194-01
Advertisement
Chapters
Table of Contents
