Chapter 6
Create Circuits and Low-Order Tunnels
As applicable, choose the following:
d.
•
•
•
•
Click Next.
Step 8
In the Destination area, complete the following:
Step 9
From the Node drop-down list, choose the node where the source will terminate.
a.
From the Slot drop-down list, choose the slot.
b.
From the Port drop-down list, choose the port.
c.
As applicable, choose the following:
d.
•
•
•
•
Click Finish.
Step 10
Stop. You have completed this procedure.
78-17194-01
From the VC4 drop-down list, choose the source VC4.
From the TUG3 drop-down list, choose the source TUG3.
From the TUG2 drop-down list, choose the source TUG2.
From the VC11 drop-down list, choose the source VC11.
From the VC4 drop-down list, choose the source VC4.
From the TUG3 drop-down list, choose the source TUG3.
From the TUG2 drop-down list, choose the source TUG2.
From the VC11 drop-down list, choose the source VC11.
NTP- D350 Create a Server Trail
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-107