Ntp- D304 Provision A Traditional Ms-Spring Dual-Ring Interconnect - Cisco ONS 15454 SDH Procedure Manual

Chapter 5 Turn Up a Network
Complete the following steps if you have not provisioned the MS-SPRings that you will interconnect in
Step 2
an MS-SPRing DRI. If the MS-SPRing are created, go to Step 3.
a. Complete the
MS-SPRings.
b. Complete the
MS-SPRings.
Complete the
c.
two-fiber MS-SPRings.
Complete the
d.
four-fiber MS-SPRings.
Verify that the MS-SPRing DRI interconnect nodes have STM-N cards installed and have fiber
Step 3
connections to the other interconnect nodes:
The STM-N cards that will connect the MS-SPRings must be installed at the interconnect nodes.
•
The interconnect nodes must have fiber connections.
•
connections for a traditional two-fiber MS-SPRing DRI.
78-17194-01
"NTP-D40 Provision MS-SPRing Nodes" procedure on page 5-10
"NTP-D41 Create the MS-SPRing" procedure on page 5-13
"NTP-D341 Two-Fiber MS-SPRing Acceptance Test" procedure on page 5-14
"NTP-D342 Four-Fiber MS-SPRing Acceptance Test" procedure on page 5-16

NTP- D304 Provision a Traditional MS-SPRing Dual-Ring Interconnect

Figure 5-4 shows an example of fiber
Cisco ONS 15454 SDH Procedure Guide, R7.0
to provision the
to create the
to test
to test
5-19