Figure - Cisco ONS 15454 SDH Procedure Manual

NTP- D329 Create a J0 Section Trace
Note
Click Next.
Step 10
In the Circuit Routing Preferences area, review the monitor circuit information. If you want the monitor
Step 11
circuit routed on a MS-SPRing protection channel, click Protection Channel Access.
Click Finish.
Step 12
From the File menu in the Edit Circuit window, click Close. The new monitor circuit appears on the
Step 13
Circuits tab.

Figure 7-1

card. To monitor the VC4 traffic, test equipment is plugged into Port 2 of the STM-1 card and a monitor
circuit to Port 2 is provisioned in Cisco Transport Controller (CTC). Circuit monitors are one-way. The
monitor circuit in
Figure 7-1
VC4 Drop
Class 5
Switch
Test Set
VC4 Monitor
Stop. You have completed this procedure.
NTP-D329 Create a J0 Section Trace
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the section trace. If you are already logged in, continue with Step 2.
In node view, double-click the MRC-12 or STM64-XFP card.
Step 2
Click the Provisioning > Line > Section Trace tabs.
Step 3
Cisco ONS 15454 SDH Procedure Guide, R7.0
7-6
In Figure 7-1, the monitor circuit destination is Port 2 on the STM-1 card.
shows an example of a monitor circuit. At Node 1, a VC4 is dropped from Port 1 of an STM-1
Figure 7-1 is used to monitor VC4 traffic received by Port 1 of the STM-1 card.
VC4 Monitor Circuit Received at an STM-1 Port
ONS 15454 SDH
Node 1
XC
Port 1
STM-1
STM-N
Port 2
This procedure creates a repeated, fixed-length string of characters used to
monitor interruptions or changes to traffic between nodes.
At least one card of the following cards must be installed: MRC-12 or
STM64-XFP.
As needed (optional if path trace is set)
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Chapter 7
ONS 15454 SDH
Node 2
XC
STM-N STM-N
at a node on the network where you will
Manage Circuits
78-17194-01