Ntp- D194 Create Overhead Circuits - Cisco ONS 15454 SDH Procedure Manual

NTP- D194 Create Overhead Circuits

On the shelf graphic, double-click the circuit source card.
Step 3
Click the Provisioning > Port tabs.
Step 4
Verify the following settings:
Step 5
•
•
•
•
Repeat Steps
Step 6
At the destination node, connect the Ethernet test set to the destination port and configure the test set to
Step 7
send and receive the appropriate Ethernet traffic.
Note
At the source node, connect the Ethernet test set to the source port and configure the test set to send and
Step 8
receive the appropriate Ethernet traffic.
Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
Step 9
between the nodes, repeat Steps
set correctly.
Perform protection switch testing appropriate to the SDH topology:
Step 10
•
•
Configure your test set according to local site practice. For information about configuring your test set,
see your test set user guide.
Complete the
Step 11
Unlocked-enabled service state.
After the circuit test is complete, print the results or save them to a disk for future reference. For
Step 12
information about printing or saving test results, see your test set user guide.
Stop. You have completed this procedure.
NTP-D194 Create Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-96
Service State—Locked-enabled,maintenance
Flow Control—Checked or unchecked as indicated by the circuit or site plan
Max Size—Check or unchecked as indicated by the circuit or site plan
Media Type—SX, LX, ZX, CWDM, or DWDM for G-Series
1 through 5 for the destination node.
At this point, you are not able to send and receive Ethernet traffic.
For SNCP rings, complete the
For MS-SPRings, complete the
"DLP-D230 Change a Circuit State" task on page 19-26
This procedure creates overhead circuits on an ONS 15454 SDH network.
Overhead circuits include DCC tunnels, IP-encapsulated tunnels, the
AIC-I card orderwire, and the AIC-I card user data channel (UDC).
None
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite or remote
Provisioning or higher
1 through 8 to make sure that you configured the Ethernet ports and test
"DLP-D94 SNCP Protection Switching Test" task on page
"DLP-D91 MS-SPRing Switch Test" task on page
Chapter 6 Create Circuits and Low-Order Tunnels
and change the circuit ports to the
17-91.
17-84.
78-17194-01