Dlp- D81 Provision A Proxy Tunnel - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
From the Target Circuit Admin State drop-down list, choose the administrative state:
Step 6
•
•
•
•
•
Step 7 Click Apply.
To close the Edit Circuit window, choose Close from the File menu.
Step 8
Return to your originating procedure (NTP).
Step 9
DLP-D81 Provision a Proxy Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the proxy server is disabled, you cannot set up a proxy tunnel.
Note
Click the Provisioning > Network > Proxy tabs.
Step 1
Click Create.
Step 2
In the Create Tunnel dialog box, complete the following:
Step 3
•
•
78-17194-01
Unlocked—Puts the member cross-connects in the Unlocked-enabled service state.
Locked,disabled—Puts the member cross-connects in the Locked-enabled,disabled service state.
Traffic is not passed on the circuit.
Unlocked,automaticInService—Puts the member cross-connects in the
Unlocked-disabled,automaticInService service state and suppresses alarms and conditions. When
the connections receive a valid signal, the service state automatically changes to Unlocked-enabled.
Locked,maintenance—Puts the member cross-connects in the Locked-enabled,maintenance
service state. The maintenance state does not interrupt traffic flow; it suppresses alarms and
conditions and allows loopbacks to be performed on the circuit. Use Locked,maintenance for circuit
testing or to suppress circuit alarms temporarily.
Locked,outOfGroup—(Future use) Puts VCAT member cross-connects in the
Locked-enabled,outOfGroup service state. This administrative state is used to put a member circuit
out of the group and to stop sending traffic.
This task sets up a proxy tunnel to communicate with a non-ONS far-end
node. Proxy tunnels are only necessary when the proxy server is enabled
and a foreign DCC termination exists, or if static routes exist so that the
DCC network is used to access remote networks or devices. You can
provision a maximum of 12 proxy server tunnels.
None
DLP-D60 Log into CTC, page 17-49
DLP-D363 Provision Regenerator-Section DCC Terminations, page 20-68
As needed
Onsite or remote
Superuser
Source Address—Type the IP address of the source node (32 bit length) or source subnet (any other
length).
Length—Choose the length of the source subnet mask.

DLP- D81 Provision a Proxy Tunnel

Cisco ONS 15454 SDH Procedure Guide, R7.0
17-73