Threshold Options For The Stm1E-12 Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-24
Table 20-24
Parameter
Port
ES
SES
BBE
UAS
EB
15 Min radio button
1 Day radio button
Table 20-25
Table 20-25
Parameter
VC4 #
Enable IPPM
SF Ber Level
SD Ber Level
Return to your originating procedure (NTP).
Step 8
78-17194-01
describes the values on the Provisioning > SDH Thresholds tab for the STM1E-12 cards.

Threshold Options for the STM1E-12 Card

Description
(Display only) Port number; 1 to 12.
Errored seconds.
Severely errored seconds.
Background block errors.
Unavailable seconds.
Errored blocks.
Clicking this radio button and then clicking Refresh will cause the threshold
values on this tab to display for 15-minute intervals.
Clicking this radio button and then clicking Refresh will cause the threshold
values on this tab to display for 1-day intervals.
describes the values on the Provisioning > VC4 tab for the STM1E-12 cards.
VC4 Options for the STM1E-12 Card
Description
(Display only) VC4 container number.
Sets intermediate path performance monitoring (IPPM).
Note To provision IPPM, circuits must be provisioned
on the STM1E-12 card. For circuit creation
procedures, go to
and Low-Order Tunnels."
go to the "DLP-D121 Enable Pointer
Justification Count Performance Monitoring"
task on page
Sets the signal fail bit error rate for the configured VC12
or VC4 circuit.
Sets the signal degrade bit error rate for the configured
VC12 or VC4 circuit.
DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card
Chapter 6, "Create Circuits
To provision IPPM,
18-19.
Cisco ONS 15454 SDH Procedure Guide, R7.0
Options
1 to 12
—
1E-3
•
1E-4
•
1E-5
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
20-53