Ntp- D348 Install The Filler Cards - Cisco ONS 15454 SDH Procedure Manual

Chapter 2 Install Cards and Fiber-Optic Cable
Slide the card along the guide rails into the correct slot.
Step 2
Close the ejectors.
Step 3
Repeat for any remaining unused card slots.
Step 4
Stop. You have completed this procedure.
NTP-D349 Install the Blank Faceplates
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Blank faceplates serve three important functions: they prevent exposure to hazardous voltages and
Warning
currents inside the chassis; they contain EMI that might disrupt other equipment; and they direct the
flow of cooling air through the chassis. Do not operate the system unless all cards and faceplates are
in place.
Always use the supplied ESD wristband when working with a powered ONS 15454_SDH. Plug the
Caution
wristband cable into the ESD jack located on the lower right outside edge of the shelf assembly and
ensure the shelf assembly is properly grounded.
Step 1 With screws, attach the blank faceplate so that it covers the empty unused FMEC slot.
Step 2 Repeat for any remaining unused FMEC slots.
Stop. You have completed this procedure.
78-17194-01
This procedure explains how to install the blank faceplates in any unused
FMEC slot. A blank faceplate card is a sheet metal cover that is used to
block any unused FMEC slot.
The blank faceplate aids in maintaining proper air flow and EMI
requirements.
Screwdriver
Blank faceplate cards (Cisco P/N 15454E-BLANK-FMEC)
NTP-D15 Install the Common Control Cards, page 2-2
NTP-D16 Install STM-N Cards and Connectors, page 2-7
NTP-D17 Install the Electrical Cards, page 2-10
NTP-D18 Install Ethernet Cards and Connectors, page 2-11
NTP-D286 Install the FC_MR-4 Cards, page 2-12
NTP-D348 Install the Filler Cards, page 2-14
As needed
Onsite
None
NTP- D349 Install the Blank Faceplates
Cisco ONS 15454 SDH Procedure Guide, R7.0
2-15