Table of Contents
Advertisement
NTP- D142 Create an E-Series Shared Packet Ring Ethernet Circuit
Number of Circuits—Leave the default (1) unchanged.
•
Auto-ranged—Unavailable.
•
Click Next.
Step 9
Provision the circuit destination:
Step 10
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
•
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits.
Size—Choose the circuit size. Valid shared packet ring circuit sizes are VC4 and VC4-2c.
•
Bidirectional—Leave the default unchanged (checked).
•
Create cross-connects only (TL1-like)—Check this check box if you want to create one or more
•
cross-connects to complete a signal path for TL1-generated circuits. If you check this box, low-order
tunnels and Ethergroup sources and destinations are unavailable.
•
State—Choose IS (in service). Ethergroup circuits are always in service.
•
Apply to drop ports—Uncheck this box; states cannot be applied to E-Series ports.
•
Protected Drops—Leave the default unchanged (unchecked).
If the circuit will be routed on an SNCP ring, complete the
Step 11
During Circuit Creation" task on page
Layer 1 SDH protection does not extend to multicard EtherSwitch circuits on SNCP rings.
Caution
Click Next.
Step 12
Provision the circuit source:
Step 13
a.
From the Node drop-down list, choose one of the shared packet ring circuit endpoint nodes. (Either
end node can be the shared packet ring circuit source.)
From the Slot drop-down list, choose Ethergroup.
b.
Step 14
Click Next.
Step 15
Provision the circuit destination:
a.
From the Node drop-down list, choose the second shared packet ring circuit endpoint node.
From the Slot drop-down list, choose Ethergroup.
b.
Click Next.
Step 16
Review the VLANs in the Available VLANs list. If the VLAN you want to use appears, continue with
Step 17
Step
18. If you need to create a new VLAN, complete the following steps:
Click the New VLAN button.
a.
In the New VLAN dialog box, complete the following:
b.
•
•
•
Click OK.
c.
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-78
VLAN Name—Assign an easily identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 SDH network
supports a maximum of 509 user-provisionable VLANs.
Topology Host—Choose the topology host ID from the drop-down list.
Chapter 6
"DLP-D218 Provision SNCP Ring Selectors
19-17.
Create Circuits and Low-Order Tunnels
78-17194-01
Advertisement
Chapters
Table of Contents
