Table of Contents
Advertisement
NTP- D286 Install the FC_MR-4 Cards
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
Warning
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
To comply with the Telcordia GR-1089 Network Equipment Building Systems (NEBS) standard for
Warning
electromagnetic compatibility and safety, connect the copper Ethernet ports to intrabuilding or
nonexposed wiring and cabling only.
Always use the supplied ESD wristband when working with a powered ONS 15454 SDH. Plug the
Caution
wristband cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Note
Cisco recommends installing TXP, MXP, STM-N, and electrical cards before you install Ethernet cards,
as applicable.
Step 1
If you installed XC-VXL-2.5G cards, review
If you installed XC-VXL-10G or XC-VXC-10G cards, review
card/slot compatibility.
Complete the
Step 2
before installing the next card.
Complete the
Step 3
E1000-2-G, G1K-4, ML1000-2, ML100X-8, ML-MR-10, CE-1000-4, or CE-MR-10 cards.
Note
Continue with
Step 4
Stop. You have completed this procedure.
NTP-D286 Install the FC_MR-4 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 SDH Procedure Guide, R8.5
2-12
"DLP-D39 Install Ethernet Cards" task on page
"DLP-D335 Install GBIC or SFP/XFP Devices" task on page 20-28
If you need to remove a Gigabit Interface Converter (GBIC) or SFP/XFP, complete the
"DLP-D336 Remove GBIC or SFP/XFP Device" task on page
"NTP-D286 Install the FC_MR-4 Cards" procedure on page 2-12
This procedure installs the FC_MR-4 card, also known as the
Fibre Channel card.
FC_MR-4 card(s)
NTP-D15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
Chapter 2 Install Cards and Fiber-Optic Cable
Table 2-1 on page 2-3
to determine card/slot compatibility.
Table 2-2 on page 2-5
17-30. Allow each card to boot completely
to determine
if you are using
20-31.
if necessary.
78-18118-01
Advertisement
Table of Contents
