Dlp- D137 Provision A J1 Path Trace On Stm-N Ports - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

Chapter 18
DLPs D100 to D199
Click Apply.
Step 4
Refresh the Ethernet statistics:
Step 5
a.
b.
Note
Step 6
Return to your originating procedure (NTP).
DLP-D137 Provision a J1 Path Trace on STM-N Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-17194-01
802.1Q VLAN CoS—For a class-of-service (CoS)-tagged frame, the CE-100T-8 can map the eight
priorities specified in CoS for either priority or best effort treatment. Any CoS class higher than the
class specified in CTC is mapped to priority, which is the treatment geared towards low latency. By
default, the CoS is set to 7, which is the highest CoS value. The default results in all traffic being
treated as best effort.
IP ToS—The CE-100T-8 can also map any of the 256 priorities specified in IP type of service (ToS)
to either priority or best effort treatment. Any ToS class higher than the class specified in CTC is
mapped to priority, which is the treatment geared towards low latency. By default, the ToS is set to
255, which is the highest ToS value. This results in all traffic being sent to the best effort queue by
default.
Note
Untagged traffic is treated as best effort.
Note
If traffic is tagged with both CoS and IP ToS, then the CoS value is used, unless the CoS
value is 7.
Click the Performance > Ether Ports > Statistics tabs.
Click Refresh.
Reprovisioning an Ethernet port on the CE-100T-8 card does not reset the Ethernet statistics for
that port.
This task monitors a path trace on VC4 high-order ports within the circuit
path.
The STM-N ports that you want to monitor must be on STM-N cards
capable of receiving path trace. See
applicable cards.
DLP-D264 Provision a J1 Path Trace on Circuit Source and Destination
Ports, page 19-68
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher

DLP- D137 Provision a J1 Path Trace on STM-N Ports

Table 19-5 on page 19-68
Cisco ONS 15454 SDH Procedure Guide, R7.0
for a list of
18-31

Advertisement

Table of Contents
loading

Table of Contents