Figure 6-3 Setting Circuit Attributes For A Low-Order Vc12 Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
Figure 6-3
If the circuit will be routed on an SNCP ring, complete the
Step 9
During Circuit Creation" task on page
Click Next.
Step 10
Complete the
Step 11
page 17-93.
In the Circuit Routing Preferences area
Step 12
available; choose either, both, or none based on your preferences.
Using Required Nodes/Spans—Check this check box if you want to specify nodes and spans to
•
include or exclude in the CTC-generated circuit route.
Including nodes and spans for a circuit ensures that those nodes and spans are in the working path
of the circuit (but not the protect path). Excluding nodes and spans ensures that the nodes and spans
are not in the working or protect path of the circuit.
Review Route Before Creation—Check this check box if you want to review and edit the circuit
•
route before the circuit is created.
78-17194-01
Setting Circuit Attributes for a Low-Order VC12 Circuit
19-17. Otherwise, continue with
"DLP-D95 Provision a Low-Order VC12 Circuit Source and Destination" task on
(Figure
NTP- D81 Create an Automatically Routed Low-Order VC12 Circuit
"DLP-D218 Provision SNCP Ring Selectors
Step
6-4), choose Route Automatically. Two options are
Cisco ONS 15454 SDH Procedure Guide, R7.0
10.
6-21