Dlp- D79 Remove Pass-Through Connections - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
from a computer to the LAN connection port on the TCC2/TCC2P card while the LAN connection port
on the MIC-C/T/P is in use as long as the computer connected directly to the TCC2/TCC2P card is not
connected to a LAN.
Step 1 Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or CAT-5 UTP Ethernet cable, connect the wires
to the RJ-45 connector according to
Table 17-2
RJ-45 Pin
1
2
3
4
5
6
7
8
Return to your originating procedure (NTP).
Step 2
DLP-D79 Remove Pass-through Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Log into the deleted node.
Step 2 In the CTC Login dialog box, check the Disable Network Discovery check box.
Step 3 Choose None from the Additional Nodes drop-down list.
Step 4 Click the Login button.
Click the Circuits tab. All internode circuits are shown as PARTIAL.
Step 5
Refer to the diagram or CTC printout you created in the
Step 6
procedure on page 14-7
circuits on the line cards of the removed node.
78-17194-01
Table
TL1 Pin Assignments
Function
NC (Not Connected)
DTR (Data Terminal Ready)
TX (Transmit)
GND (Ground)
GND (Ground)
RX (Receive)
NC (Not Connected)
NC (Not Connected)
This task removes pass-through connections from a node deleted from a
ring.
None
DLP-D60 Log into CTC, page 17-49
NTP-D213 Remove an MS-SPRing Node, page
Remove an SNCP Node, page 14-12
As needed
Onsite or remote
Provisioning or higher
or the "NTP-D106 Remove an SNCP Node" procedure on page

DLP- D79 Remove Pass-through Connections

17-2.
"NTP-D213 Remove an MS-SPRing Node"
Cisco ONS 15454 SDH Procedure Guide, R7.0
14-7, or NTP-D106
14-12. Find the
17-71