Cisco ONS 15454 SDH Procedure Manual page 520

DLP- D107 Preprovision an SFP or XFP Device
Click Retrieve Last Activity Time to display the most recent activity date and time for users in the
Step 3
Last Activity Time field.
Step 4 Return to your originating procedure (NTP).
DLP-D107 Preprovision an SFP or XFP Device
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Before you install SFPs on the MRC-12 card, refer to the MRC-12 information in the Cisco ONS 15454
Note
SDH Reference Manual for bandwidth restrictions based on the port where you install the SFP and the
cross-connect card being used.
Note If you preprovision a multirate SFP, you must next select the line rate using the
a Multirate PPM on the MRC-12 Card" task on page
In node view, click the Alarms tab:
Step 1
a.
b.
c.
In node view, double-click the card where you want to provision PPM settings.
Step 2
Click the Provisioning > Pluggable Port Modules tabs.
Step 3
In the Pluggable Port Modules area, click Create. The Create PPM dialog box appears.
Step 4
In the Create PPM dialog box, complete the following:
Step 5
•
•
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-8
This procedure preprovisions Small Form-factor Pluggables (SFPs/XFPs)
on the MRC-12 and STM64-XFP cards. The SFPs/XFPs are referred to as
pluggable port modules (PPMs) in CTC. Cisco-approved STM-1, STM-4,
STM-16, STM-64, and multirate PPMs are compatible with the
ONS 15454 SDH. See
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
None
Verify that the alarm filter is not turned on. See the
page 19-25 as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide.
Complete the "DLP-D147 Export CTC Data" task on page 18-38
information.
PPM—Choose the slot number where you want to preprovision the SFP/XFP from the drop-down
list.
PPM Type—Choose the number of ports supported by your SFP/XFP from the drop-down list. If
only one port is supported, PPM (1 port) is the only option.
Chapter 18
Table 20-9 on page 20-29
18-27.
"DLP-D227 Disable Alarm Filtering" task on
to export alarm and condition
DLPs D100 to D199
for a list.
"DLP-D132 Provision
78-17194-01