Before You Begin - Cisco ONS 15454 SDH Procedure Manual

Install the Shelf and FMECs
This chapter explains how to install the Cisco ONS 15454 SDH shelf assembly. For a summary of the
tools and equipment required for installation, see the
page

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs). Read
the installation procedures and precautions before you install the ONS 15454 SDH and connect the
power source.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
78-17194-01
1-2.
NTP-D1 Unpack and Inspect the ONS 15454 SDH Shelf Assembly, page
procedure before continuing with the
NTP-D2 Install the Shelf Assembly, page
assembly in a rack.
NTP-D3 Open and Remove the Front Door, page
equipment before continuing with other procedures in this chapter.
NTP-D219 Open and Remove the FMEC Cover, page
electrical facility connection assembly (EFCA) for the front mount electrical connections (FMECs)
before continuing with other procedures in this chapter.
NTP-D220 Install the Power and Signal FMECs, page
install electrical cards. This procedure is a prerequisite to the
Cables on the FMECs" procedure on page
NTP-D6 Install the Power and Ground, page
the "NTP-D7 Install the Fan-Tray Assembly" procedure on page
NTP-D7 Install the Fan-Tray Assembly, page
assembly in the shelf.
NTP-D222 Install the E1-75/120 Conversion Panel, page
the E1-42 card and plan to use 75-ohm unbalanced interfaces.
NTP-D223 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
as needed to set up wire-wrap pin connections and craft connections.
NTP-D224 Install the Electrical Card Cables on the FMECs, page
if you will install electrical cards.
NTP-D10 Route Electrical Cables, page
C H A P T E R
"Required Tools and Equipment" section on
"NTP-D2 Install the Shelf Assembly" procedure on page
1-5—Complete this procedure to install the shelf
1-6—Complete this procedure to access the
1-7—Complete this procedure to access the
1-7—Complete this procedure if you plan to
"NTP-D224 Install the Electrical Card
1-16.
1-10—Complete this procedure before continuing with
1-11—Complete this procedure to install the fan-tray
1-13—Complete this procedure if you use
1-16—Complete as needed.
Cisco ONS 15454 SDH Procedure Guide, R7.0
1
1-4—Complete this
1-11.
1-15—Complete
1-16—Complete this procedure
1-5.
1-1