Dlp- D459 Clear Selected Pm Counts - Cisco ONS 15454 SDH Procedure Manual

DLP- D459 Clear Selected PM Counts

DLP-D459 Clear Selected PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Pressing the Clear button can mask problems if used incorrectly. This button is commonly used for
Caution
testing purposes. After pressing this button, the current bin is marked invalid. Also note that the
unavailable seconds (UAS) state is not cleared if you were counting UAS; therefore, this count could be
unreliable when UAS is no longer incrementing.
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Step 2 Click the Performance tab.
Step 3 Click Clear.
Step 4 In the Clear Statistics dialog box, choose one of the following options:
•
•
•
Choose OK to clear the selected statistics.
Step 5
Verify that the selected PM counts have been cleared.
Step 6
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-36
Displayed statistics—Clearing the displayed statistics erases from the card and the window all PM
counts associated with the current combination of statistics on the selected port. This means that the
selected time interval, direction, and signal type counts are erased from the card and the window.
All statistics for port x—Clearing all statistics for port x erases from the card and the window all
PM counts associated with all combinations of the statistics on the selected port. This means that all
time intervals, directions, and signal type counts are erased from the card and the window.
All statistics for card—Clearing all statistics for a card erases from the card and the window all PM
counts for all ports.
This task uses the Clear button to clear specified PM counts depending
on the option selected.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser
Chapter 21 DLPs D400 to D499
78-17194-01