Ntp- D230 Replace The Fan-Tray Assembly - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:

Table of Contents

NTP- D230 Replace the Fan-Tray Assembly

Determine the active XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G card. The ACT/STBY LED of the

active card is green. The ACT/STBY LED of the standby card is amber.

If you want to replace the active card, you must first switch it to standby by completing the following

substeps. If you want to replace the standby card, skip this step and continue with

Physically remove the standby XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G card from the

ONS 15454 SDH.

Insert the replacement XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G card into the empty slot.

The replacement card boots up and becomes ready for service after approximately one minute.

Stop. You have completed this procedure.

NTP-D230 Replace the Fan-Tray Assembly

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Do not force an FTA into place. Doing so can damage the connectors on the fan tray and/or the

connectors on the back panel of the shelf assembly.

To replace the FTA, it is not necessary to move any of the cable management facilities.

Cisco ONS 15454 SDH Procedure Guide, R7.0

Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve

them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.

You can also place the cursor over the card graphic to display a popup identifying the card as

active or standby.

In the node view, click the Maintenance > Cross-Connect tabs.

In the Cross Connect Cards area, choose Switch.

Click Yes in the Confirm Switch dialog box.

After the active XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G goes into standby, the

original standby slot becomes active. This causes the ACT/STBY LED to become green on

the former standby card.

This procedure replaces a malfunctioning fan-tray assembly (FTA).

Maintain the Node

Table of Contents