Cisco ONS 15454 SDH Procedure Manual page 694

DLP- D321 Open the FMEC Cover
If you need to create a secondary source, for example, an SNCP ring bridge/selector circuit entry point
Step 6
in a multivendor SNCP ring, click Use Secondary Source and repeat Steps
secondary source. If you do not need to create a secondary source, continue with
Click Next.
Step 7
Step 8 From the Node drop-down list, choose the destination (termination) node.
Step 9 From the Slot drop-down list, choose the slot containing the destination card. The destination is typically
a E3 or DS3 card. However, you can also choose an STM-N card to map the VC3 to a VC4 for optical
transport.
Depending on the destination card, choose the destination port from the drop-down lists that appear
Step 10
based on the card selected in
Transport Controller (CTC) does not show ports, VC4s, or VC3s already used by other circuits.
Note
Step 11 If you need to create a secondary destination, for example, an SNCP ring bridge/selector circuit exit
point in a multivendor SNCP ring, click Use Secondary Destination and repeat Steps
define the secondary destination.
Click Next.
Step 12
Step 13 Return to your originating procedure (NTP).
DLP-D321 Open the FMEC Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Unscrew the screws on the FMEC cover
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-10
Step
If you and a user working on the same network choose the same port, VC4, or VC3
simultaneously, one of you receives a Path in Use error and is unable to complete the circuit. The
user with the PARTIAL circuit needs to choose new destination parameters.
This task opens the Front Mount Electrical Connection (FMEC) cover.
Medium slot-head screwdriver
DLP-D8 Open the Front Cabinet Compartment (Door), page 17-9
Required
Onsite
None
2. See Table 6-2 on page 6-3
(Figure 20-3).
Chapter 20 DLPs D300 to D399
1 through 5 to define the
Step 7.
for a list of valid options. Cisco
8 through 10 to
78-17194-01