Dlp- D212 Create A User Data Channel Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
Refresh the Ethernet statistics:
Step 5
a.
b.
Note
Return to your originating procedure (NTP).
Step 6
DLP-D212 Create a User Data Channel Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Click Create.
Step 2
In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
Step 3
•
•
Click Next.
Step 4
In the Circuit Source area, complete the following:
Step 5
•
•
•
Step 6 Click Next.
Step 7 In the Circuit Destination area, complete the following:
•
•
•
Click Finish.
Step 8
78-17194-01
Click the Performance > Ether Ports > Statistics tabs.
Click Refresh.
Reprovisioning an Ethernet port on the CE-1000-4 card does not reset the Ethernet statistics for
that port.
This task creates a user data channel (UDC) circuit on the
ONS 15454 SDH. A UDC circuit allows you to create a dedicated data
channel between nodes.
STM cards must be installed.
NTP-D24 Verify Card Installation, page 4-2
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Type—Choose either User Data-F1 or User Data D4-D12 from the drop-down list.
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.

DLP- D212 Create a User Data Channel Circuit

Cisco ONS 15454 SDH Procedure Guide, R7.0
19-9