Ntp- D222 Install The E1-75/120 Conversion Panel - Cisco ONS 15454 SDH Procedure Manual

Chapter 1 Install the Shelf and FMECs
Stop. You have completed this procedure.
NTP-D222 Install the E1-75/120 Conversion Panel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For more information about the E1-75/120 conversion panel, refer to the Cisco ONS 15454 SDH
Note
Reference Manual.
Lift the E1-75/120 conversion panel to the desired rack position.
Step 1
Figure 1-3
78-17194-01
This procedure installs the E1-75/120 conversion panel. You need an
E1-75/120 conversion panel if you want to convert the balanced 120-ohm
interfaces of the E1-42 card and the corresponding FMECs to unbalanced
75-ohm interfaces.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
96-conductor cables with Molex 96-pin LFH connectors
NTP-D2 Install the Shelf Assembly, page 1-5
NTP-D3 Open and Remove the Front Door, page 1-6
As needed
Onsite
None
shows the rack-mounting for the E1-75/120 conversion panel.

NTP- D222 Install the E1-75/120 Conversion Panel

Cisco ONS 15454 SDH Procedure Guide, R7.0
1-13