Table of Contents
Advertisement
NTP- D344 Open-Ended SNCP Acceptance Test
•
Note
Repeat Steps
Step 5
As needed, complete the
Step 6
As needed, complete the
Step 7
Step 8
Following the documentation provided by the third-party vendor, provision the optical loop leading from
the ONS 15454 SDH connection at one end to the ONS 15454 connection at the other end. In other
words, you will create an open-ended SNCP using procedures for the third-party equipment.
Complete the
Step 9
Stop. You have completed this procedure.
NTP-D344 Open-Ended SNCP Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
traffic traversing the third-party network. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab.
Step 3
a.
b.
c.
Click the Conditions tab.
Step 4
a.
b.
Cisco ONS 15454 SDH Procedure Guide, R7.0
5-36
Node 3 and 4: Slot 5
If an ONS 15454 SDH is not connected to a corporate LAN, DCC or MS-DCC provisioning
must be performed through a direct (craft) connection. Remote provisioning is possible only
after all nodes in the network have DCC or MS-DCC terminations provisioned to
Unlocked-enabled STM-N ports.
3
and
4
for each node in the SNCP.
"DLP-D81 Provision a Proxy Tunnel" task on page
"DLP-D90 Provision a Firewall Tunnel" task on page
"NTP-D344 Open-Ended SNCP Acceptance Test" procedure on page
This procedure tests an open-ended SNCP ring.
Test set and cables appropriate to the test circuit you will create.
NTP-D258 Provision an Open-Ended SNCP, page 5-34
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
Verify that the alarm filter is not on. See the
page 19-25
as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if necessary.
Complete the
"DLP-D147 Export CTC Data" task on page 18-38
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide if
necessary.
Complete the
"DLP-D147 Export CTC Data" task on page 18-38
information.
at the node that will be the source node for
"DLP-D227 Disable Alarm Filtering" task on
to export the alarm information.
to export the conditions
Chapter 5
Turn Up a Network
17-73.
17-83.
5-36.
78-17194-01
Advertisement
Chapters
Table of Contents
