Dlp- D436 Delete Ethernet Rmon Alarm Thresholds - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
DLP-D436 Delete Ethernet RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The ONS 15454 SDH ML-Series cards use the Cisco IOS command line interface (CLI) for managing
Note
RMON.
Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 1
In card view, click the Provisioning > RMON Thresholds tabs.
Step 2
Click the RMON alarm threshold you want to delete.
Step 3
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Yes to delete that threshold.
Step 6 Return to your originating procedure (NTP).
DLP-D437 Change Node Access and PM Clearing Privilege
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Access tabs.
Step 1
In the Access area, provision the following:
Step 2
•
78-17194-01
This task deletes remote monitoring (RMON) threshold crossing alarms
for Ethernet ports.
None
DLP-D441 Create Ethernet RMON Alarm Thresholds, page 21-28
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
This task provisions the physical access points and shell programs used to
connect to the ONS 15454 SDH and sets the user security level that can
clear node performance monitoring data.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser
LAN access—Choose one of the following options to set the access paths to the node:
No LAN Access—Allows access to the node only through data communications channel (DCC)
–
connections. Access through the TCC2/TCC2P RJ-45 port and backplane is not permitted.
Front only—Allows access through the TCC2/TCC2P RJ-45 port. Access through the DCC and
–
the backplane is not permitted.

DLP- D436 Delete Ethernet RMON Alarm Thresholds

Cisco ONS 15454 SDH Procedure Guide, R7.0
21-25