Dlp- D425 Create A New Or Cloned Alarm Severity Profile - Cisco ONS 15454 SDH Procedure Manual

DLP- D425 Create a New or Cloned Alarm Severity Profile

DLP-D425 Create a New or Cloned Alarm Severity Profile
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Access the alarm profile editor. To do this:
Step 1
•
•
•
•
If you want to create a new profile based upon the default profile in use, click New. Then go to
Step 2
If you want to create a profile using an existing profile located on the node:
Step 3
a.
b.
c.
If you want to create a profile using an existing profile located in a file that is stored locally or on a
Step 4
network drive:
a.
b.
c.
d.
Note
Click OK.
Step 5
The alarm severity profile appears in the Alarm Profiles window
contains a master list of alarms that is used for a mixed node network. Some of these alarms might not
be used in all ONS nodes.
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-6
This task creates a custom severity profile or clones and modifies the
default severity profile.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
From network view, click the Provisioning > Alarm Profiles tabs.
the network view.
From node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
From card view for an FC_MR-4, E-Series Ethernet, G-Series Ethernet, STM-N, or electrical
(DS3i-N-12, E-1, E1-42, or E-3) card, click the Provisioning > Alarm Profiles >
Alarm Profile Editor tabs.
From card view for an ML-Series Ethernet (traffic) card, click the Provisioning >
Ether Alarming > Alarm Profile Editor tabs or the Provisioning > POS Alarming >
Alarm Profile Editor tabs, depending on whether you want to apply the profile to the front physical
ports ("Ether alarming") or packet over SDH ("POS alarming"). For more information about
ML-Series card ports and service, see the Ethernet Card Software Feature and Configuration Guide
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Click Load and From Node in the Load Profile(s) dialog box.
Click the node name you are logged into in the Node Names list.
Click the name of an existing profile in the Profile Names list, such as Default. Then go to
Click From File in the Load Profile(s) dialog box.
Click Browse.
Navigate to the file location in the Open dialog box.
Click Open.
All default or user-defined severity settings that are Critical (CR) or Major (MJ) are demoted to
Minor (MN) in Non-Service-Affecting (NSA) situations as defined in Telcordia GR-474.
Chapter 21 DLPs D400 to D499
Figure 21-2 on page 21-7
(Figure 21-2). The alarm profile list
shows
Step 8.
Step 5.
78-17194-01