Dlp- D109 Change Optics Thresholds Settings For Stm-64 And Mrc-12 Cards - Cisco ONS 15454 SDH Procedure Manual

DLP- D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards

Table 18-1 STM-N Card Line Settings (continued)
Parameter Description
Reach (Does not apply to all cards) Allows you to
provision the reach value. You can also choose
Auto Provision, which allows the system to
automatically provision the reach from the PPM
reach value on the hardware.
Wavelength (Does not apply to all cards) Allows you to
provision the wavelength frequency.
Step 5 Return to your originating procedure (NTP).
DLP-D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to change the optics settings.
Step 1
Click the Provisioning > Optics Thresholds tabs.
Step 2
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-12
Options
The options that appear in the drop-down list depend on
the card:
SR (short reach, up to 2 km distance)
•
SR-1 (up to 2 km distance)
•
IR-1 (intermediate reach, up to 15 km distance)
•
IR-2 (up to 40 km distance)
•
LR-1 (long reach, up to 40 km distance)
•
LR-2 (up to 80 km distance)
•
LR-3 (up to 80 km distance)
•
• First Tunable Wavelength
• 1310 nm
• 1550 nm
1470 nm
•
1490 nm
•
1510 nm
•
1530 nm
•
1570 nm
•
1590 nm
•
1610 nm
•
This task changes the optics thresholds settings for STM-64 and MRC-12
cards.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs D100 to D199
78-17194-01